Powder Coat Tech I (Conversion Temp to hire)

Minimum Qualifications
High School Diploma, GED preferred. Technical School or Associates Degree in Coatings technology high desired. However, a combination of education and relevant work experience will be considered.
Ability to read and interpret documents, work instructions, UL Standard, written directions.
Ability to use the computer and enter information in database.
Knowledge of measurement tools, tape measures.
Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals.
Ability to read and communicate in English.

Essential Functions
Maintains safe and healthy work environment by following standards and procedures; complying with legal regulations.
This position must be able to understand the equipment, the standards, and general manufacturing practices in the Generator enclosure and power switchgear product areas.
Identify and follow proper procedure for all non-conforming material. Assist in ensuring all material discrepancies are tracked and recorded.
Communication and cooperation with the engineering, manufacturing, and quality department to ensure quality compliance and continual product improvement.

Level 1
• Has been trained how to, load and unload the Powder Coat Line.
• Has shown competency in reading applicable documents and a fine attention to detail.
• Has demonstrated the ability to complete work in a timely fashion.
• Knowledgeable about all required department procedures.

Physical Demands
Limited local travel will not be required.
Must be able to work in a fast-paced environment and have constant control over Powder Coat environment.
Must be able to lift 60lbs and manipulate heavy finished panels.
Manual dexterity to operate digital equipment, including computers, HMIs, and other such equipment with small fine buttons and operators.